This document focuses on the lower-level details if you want to configure corosync yourself. Corosync configuration is normally located in /etc/corosync/ ...
関連する質問
What is the difference between corosync and Pacemaker?
What is corosync used for?
How to enable corosync?
Is corosync open source?
2023/02/14 · The following test is done by using "iptables" to drop all traffic on each ring's port (one at the time), NOT on the IP address.
2022/02/15 · I have two "linknumber" entries defined under the Cluster Totem, where each corresponds to a ring0/1_address on each of the nodes.
2023/11/15 · I am pleased to announce the latest maintenance release of Corosync 3.1.8 is available immediately from the GitHub release section.
2022/07/25 · Fencing considerations, quorum settings, and commands for sensible behavior in a two-node Pacemaker with Corosync cluster.
The Corosync Cluster Engine is an open source implementation of the Totem Single Ring Ordering and Membership protocol.
Using pcs with the pcs daemon greatly simplifies this process by generating corosync.conf across all the nodes in the cluster with a single command.
2017/02/10 · Pacemaker service can be run only as a plugin for Corosync service. We cannot restart pacemaker separately from the corosync and vice versa.
2012/04/23 · At its most basic level it is a quorum-based majority voting system where a cluster needs expected_votes/2+1 votes for it to be quorate. This ...
2019/02/22 · A two-node cluster would only have quorum when both nodes are running. This would make the creation of a two-node cluster pointless.